| SNo |
IS Number |
Title |
Technical Committee |
|
1 |
IS 110 : 2017 |
Ready mixed paint, brushing, grey filler, for enamels for use over primers - Specification (Third Revision) |
CHD 20 |
|
2 |
IS 210 : 2009 |
Grey iron castings - Specification (Fifth Revision) |
MTD 6 |
|
3 |
IS 226 : 1975 |
Structural steel (Standard quality) |
MTD 4 |
|
4 |
IS 292 : 1983 |
Specification for leaded brass ingots and casting (Second Revision) |
MTD 8 |
|
5 |
IS 320 : 1980 |
Specification for high tensile brass rods and sections (Other Than Forging Stock) (Second Revision) |
MTD 8 |
|
6 |
IS 410 : 1977 |
Specification for cold rolled brass sheet, strip and foil (Third Revision) |
MTD 8 |
|
7 |
IS 617 : 1994 |
Cast aluminium and its alloys - Ingots and castings for general engineering purposes - Specification (Third Revision) |
MTD 7 |
|
8 |
IS 737 : 2008 |
Wrought aluminium and aluminium alloy sheet and strip for general engineering purposes - Specification (Fourth Revision) |
MTD 7 |
|
9 |
IS 742 : 1981 |
Specification for zinc base alloy die castings (Second Revision) |
MTD 9 |
|
10 |
IS 2932 : 2003 |
Enamel, Synthetic, Exterior : (a) Undercoating (b) Finishing |
CHD 20 |
|
11 |
IS 2933 : 2013 |
Enamel exterior (a) undercoating, (b) finishing |
CHD 20 |
|
12 |
IS 3098 : 1983 |
Specification for oil, hydraulic, mineral oil type (Second Revision) |
PCD 25 |
|
13 |
IS 3618 : 1966 |
Specification for phosphate treatment of iron and steel for protection against corrosion |
MTD 24 |
|
14 |
IS 4454 : Part 2 : 2001 |
Steel wire for mechanical springs - Specification february 2001: Part 2 oil hardened and tempered steel wire (Second Revision) |
MTD 4 |
